- Natural stones - Marble - Granite - Travertine - Sandstone - Limestone

CLEANING
- The surface must be clean, completely dry and free from all layers and coatings
- In outdoor areas it must be taken care that the stone does not contain any harmful salts since these reduce the absorptive capacity of the stone
- Surface Temperature should be between 10 to 35 deg C
- Surface should be sound and free from all dirt
- In any case, after cleaning rinse well with water. Before the stone is given its protective treatment, it must be totally dry. As a rule, this is the case after 1-2 days at the earliest
- Ensure that the area is well ventilated

PREPARATION OF A SAMPLE AREA

Before starting we recommend preparing a sample area of 1-2 m² to examine the efficiency of the impregnation, to evaluate the appearance of the treated object and to ascertain the material consumption as exactly as possible

IMPREGNATION PROCEDURE
- Shake well before use. The best condition for impregnating is a temperature of 5o-35o C and protection from humidity for approx. 2-3 hours
- The stone must not be warmed up by an underfloor heating or direct sunlight
- In general, one to two coat wet-in-wet are sufficient
- Apply the product with a brush or a mop. Spread liberally over the substrate
- Allow sealer to penetrate the surface for 15-30 minutes
- Any excess material which has not been absorbed by the stone has to be completely removed with a suitable cloth. Polished surfaces must additionally be polished again until any blooming on the surface is removed
- If the desired effect is not achieved or if the impregnation has been applied unevenly, it is possible to apply the impregnation once again
- The water-repellent effect develops after a few minutes, full protection after 24-72 hours
- A full cure is achieved after 24-72 hrs. Foot traffic is allowed after 6-8 hrs
- Sufficient ventilation (approx. 2-3 days) is necessary when using the product in food areas
- Tools can be cleaned with thinner or mineral spirit